The LM-2/3 is a cost effective power amplifier representing the state-of-the-art in professional quality performance. It is optimized to deliver high levels of sustained power, extraordinary audio performance, and road-proven reliability.
The LM-2/3 is a "Heavy Duty" models specially designed to work as hard into 2 ohm as most. With 3 TIERS power rails, Class H design, the amplifier work in extremely high efficiency because of less current consumption and heat dissipation
FEATURES
ØHigh-current toroidal transformers for greater 2 ohm power and low noise
ØSelectable input sensitivity in voltage 0.775V rms, 1.0V rms and 1.4V rms
ØSwitch for sub sonic filter 30Hz and below
ØSwitch for Earth link (on and off)
ØComprehensives Signal (SIG), CLIP (CLIP), Protect (PRO) and PAR/BRG (Parallel/Bridged) indicators to monitor amplifier working status.
ØAll signal inputs and outputs are on XLR male & female (2x XLR male & 2x XLR female)
ØBinding post and Speakon outputs
SPECIFICATIONS |
STEREO MODE | LM-3 | LM-2 |
8ohms (RMS/THD 1%) | 1300Wx2 | 1000Wx2 |
4ohms (RMS/THD 1%) | 2000Wx2 | 1700Wx2 |
2ohms | 2200Wx2 | 1800Wx2 |
BRIDGE MONO MODE | | |
8ohms | 4000W | 3500W |
4ohms | n/a | n/a |
| | |
Signal to Noise | >95dB | |
Input Sensitivity | 0.775Vrms/1.0Vrms/1.4Vrms | |
Gain @ 8homs | 38dB | |
Output Circuitry | 3-Tier Class H | |
Distortion | Less than 0.02% | |
Frequency Response | 20Hz-20KHz @ 8ohms ±0.5dB | |
Damping Factor (@100Hz) | >300 | |
Input Impedance | Balanced 20K/ Unbalanced 10K | |
Switching Rate | >20V/us | |
High Filter | 30Hz at -3dB | |
Cooling | Variable-speed fan, rear-to-front air flow |
Input Connectors, each channel | XLR male & female | |
Output Connectors, each channel | speakon and binding posts | |
Rear Panel Swithches | Input Configuration: Bridge/Stereo/Parallel |
| Input sensitivity:0.755Vrms,1.0VRMS and 1.4Vrms |
| Sub sonic filter: 30Hz and below | |
| Earth link: on/off | |
Front Panel Controls | Gain Attenuator: 0 to ∞ dB Power On/Off |
Front Panel Indicators | Signal (SIG), CLIP (CLIP), Protect (PRO) and PAR/BRG (Parallel/Bridged) |
| Power STY/on | |
Protection | | |
Amplifier Protection | Full short circuit, thermal, infrasonic, ultrasonic,VHF,vol.gain gradually |
Load Protection | DC fault power supply,switching power supply under voltage, |
Infrasonic | -3 dB, 5 Hz | |
DC fault | Power supply shutdown | |
Ultrasonic | -3 dB, 85 kHz | |
Short Circuits | active clip limiting, recover after limiting |
Thermal | no output at 95°C, re-work less than 95°C |
Over Current | auto limit | |
PHYSICAL | | |
SHIPPING WEIGHT (kgs) | 29.6KG | 28.7KG |
SHIPPING SIZE ( WxDxH mm) | 575x605x210 |